Separate names with a comma.
Fro memory the last one I did I went from .060 to .120 taking .030 from each side.
I've found opening up the groove in the cam journal helps, depending on the thickness of the torrington bearing behind the cam gear sometimes the...
I'm looking for some input on using a 9 inch rear end in a top alcohol funny car compared to the 10.5 top loaders or MW 11 inch?, I'm planning on...
Venturi effect, the fuel flowing through the nozzle creates a vacuum pulling air in through the hole
Definatly 48* cams, it was the first thing I checked. Its only on number 6 cylinder not the whole bank
I have come across this on a few different engines (Hemi's) with different cam / lifter / rocker setups where the lash on number 6 intake when set...
If you're happy with your current tune up air density online has a pro calc that you pay a subscription for, if you put in your current fuel...
Thanks, you were half right about someone modifying them, the valves were 50 seats still 45!
Can anybody tell me what angle the intake seat should be on a BAE V fat head?
What's the best way to remove 1 piece `o` ring wires?
Mike I have sent you an email with some pics. The more I think about it it seems to be more in the forged rods than the billets.
