Separate names with a comma.
steel rods ok guys,572 chevy,blown alcohol,14 71 hh blower,55overdrive,oliver steel rods,50 plus runs,bearings just as they came out of the...
fasttimes,18 lbs is a good starting point for the port check,a high helix blower has a pie shaped opening in the front of the blower,the setback...
oil div6 safety.things to consider when choosing oil weight,bearing clearance,amount of hp produced&do you preheat oil before run.also,rpm,s.we...
on my kb olds i have .008 to .010.clearance,it will grow some as it gets warmed up.
reciever groove i have the same setup on one of my engines,with .012 up,you need .012 to .015 deep groove,.060 wide.it works for me.
clayto,i see no reason you can,t do it with a standard helix blower,afterall,it is less efficient than a hh blower
high speed clayto,when you position the high speed lean on the port line side of the barrelvalve,it is easier to get the correct percent of fuel...
rods r&r vs brooks.i have installed both brands in blown alky engines,and had no rod failures due to the rods.i recall one time the arias 8.3L...
4 years at 40 runs and no failure,you answered your question,don,t change your maintance program,it,s working.a friend of mine uses miller rods in...
arias i forgot to mention,arias then started to make a block they called the 10L it is basically a carbon copy of a kb600 also known as kb...
arias arias origionally made the 8.3L block,that program was baught buy a company called [barnes fontana].then the company split ,barnes went on...
