Separate names with a comma.
Only at 20 over Jason. Thought this was gunna be an issue for Spud............ Maybe not
Ok thanks. So, after looking at the belt cross section dimensions it would seem a GT belt should only go on a GT pulley, and same with HTD? So to...
So wats the difference between 14mm and 14mm gt pulleys and belts? I see some sites offering Kevlar belts in 14mm and Carbon in 14mmGT.
Pushrod length is also important. Make sure the oil feed in the adjuster lines up with the supply hole in the rocker. Also check that shaft is in...
Any one know why they went to so much trouble to get oil back down in the rear of these blocks? They have galleries that put it into the very rear...
start up a switch on the blower solves that. who would ever rely on a driver?
6 shooter To be clear........ A 2 in the second hole gives 27 - 2 = 25
So, if you have say 27 degrees on the mag with a zero chip in the first hole, then take the zero out and replace it with a 3 chip I can see on the...
