Recent Content by koister

  1. koister
    Post

    4 Link Setup Help

    I am running Goodyear 17x33 D4 compound. I run 5 3/4 lb tire pressure in them.
    Post by: koister, Jan 4, 2015 in forum: PSI Superchargers Tech Questions
  2. koister
    Post

    4 Link Setup Help

    What you say makes sense. They got that high because i kept moving them up thinking that up correlated to softer hit on the bars. I guess that...
    Post by: koister, Jan 4, 2015 in forum: PSI Superchargers Tech Questions
  3. koister
    Post

    Littlefield 1271 hi helix injectors(at top rear of blower) are squirting alcohol idle

    swapped rotors Thanks for the input. I serviced the blower and obviously installed the rotors wrong. I didnt think that they looked right...
    Post by: koister, Jan 4, 2015 in forum: PSI Superchargers Tech Questions
  4. koister
    Thread

    4 Link Setup Help

    Hi Everyone, I have a 1965 Plymouth Belvedere 114 inch wheel base. about 2600 lbs 572 Blown Alcohol Hemi 28 lbs boost. Powerglide with Neil...
    Thread by: koister, Jan 4, 2015, 7 replies, in forum: PSI Superchargers Tech Questions
  5. koister
    Post

    Littlefield 1271 hi helix injectors(at top rear of blower) are squirting alcohol idle

    Thanks for the reply. I thought that might be the problem but wanted to ask before i tore the hole thing apart again. ken
    Post by: koister, Dec 21, 2014 in forum: PSI Superchargers Tech Questions
  6. koister
    Thread

    Littlefield 1271 hi helix injectors(at top rear of blower) are squirting alcohol idle

    Hi, I just put new teflon strips in the blower reassembled it started the car an alcohol is shooting out of the injectors that are located at the...
    Thread by: koister, Dec 21, 2014, 4 replies, in forum: PSI Superchargers Tech Questions
  7. koister
    Post

    Blower Turns Hard after sitting for a month and hence slow cranking and no MSD spark

    I have been absent. Thanks for the replies I am going to be taking the Blower off the engine and will then disassemble the blower to see what...
    Post by: koister, Dec 1, 2014 in forum: PSI Superchargers Tech Questions
  8. koister
    Post

    Blower Turns Hard after sitting for a month and hence slow cranking and no MSD spark

    I spoke with JR at RBS Superchargers Hey Mike, I spoke with JR at rbs superchargers. He said that the lube can cause the teflon to swell....
    Post by: koister, Nov 25, 2014 in forum: PSI Superchargers Tech Questions
  9. koister
    Post

    Blower Turns Hard after sitting for a month and hence slow cranking and no MSD spark

    Thanks for the input Mike. I do you Prizm, at least i think i do. I am using a PTFE which i think is Prizm. Purchased from RBS Superchargers. But...
    Post by: koister, Nov 22, 2014 in forum: PSI Superchargers Tech Questions
  10. koister
    Thread

    Blower Turns Hard after sitting for a month and hence slow cranking and no MSD spark

    Hi, I have a Blown Alcohol 527 ci Hemi which resides in a 1965 Plymouth Belvedere. So I was busy and couldnt go racing for several months ok 5...
    Thread by: koister, Nov 22, 2014, 17 replies, in forum: PSI Superchargers Tech Questions
  11. koister
    Post

    Blown Alcohol Hemi Water Block and Head Engine Overheats

    I put another flat into the barrel valve at the track and checked it when i got the car back to the shop and leakdown was 42%. Do think i just...
    Post by: koister, Jan 27, 2014 in forum: PSI Superchargers Tech Questions
  12. koister
    Thread

    Blown Alcohol Hemi Water Block and Head Engine Overheats

    Hi, I am running a blown alcohol 572 CI Hemi water block and heads. Running it with water radiator and water pump. I was running the engine...
    Thread by: koister, Jan 27, 2014, 7 replies, in forum: PSI Superchargers Tech Questions