Separate names with a comma.
I use marvel mystery oil. Blow it thru everything.
I would think since it is a NA engine, that a .062 copper would safe. Maybe even a .050.
And if I am correct, does this make it a 48 degree lifter angle setup?
Yes sir. From everything I have read, 8 1/2" is std deck so your 8 9/16 is probably same.
From what I have read, 8.5" is a standard deck. 9" is .100 tall. beyond that have not found anything...
I measured as best I could. Got 9.250 across front end of manifold.
Hey guys, looking for info on a KB block. Do any of you know who to contact that can decipher a serial number on a Hemi block? I haven't been...
down loading the run and trying to decipher it. Then if you happen to turn on battery switch, the run is gone. I guess I need to just sit down...
Does anyone else use the Altronics Red Alert EGT system with 8 probes? Is this complicated to use or am I making it hard somehow? The...
Are you talking about the Output Switch?
and??
After further investigation and questions asked, I believe that I can use the MSD 7760 to activate the leanout as desired. Does anyone else use...
Is there a way to wire up the leanout thru the steps in the grid? I have the shifter wired thru the Output Switch. I am wanting to turn the...
