Separate names with a comma.
Yes very good work and almost dirt cheap!!!!
Hi Mikel I do have nEw psi C complete set up Send me a pm IF Interested
As I understand the lenco TWO SPEED CASE is .187 Longer than the case used on the three speed and all others .
lm Actually Mike at b&j has a good low amp draw selenoid for his trans
The main fact is the car actually becomes an accurate flowmeter and when used with a good baseline and program like jetsize accurates changes can...
i understand it takes 750hp to get the blower at 50pds on a complete engine but i believe if you are flowing only one port at 45 pds them a 100hp...
Maybe Will can verify this but from my perspective they are using the spintron to only drive the blower thru the crankshaft, there is no cam on...
Sir You had made a beautifull and respectfull post stating your thoughts and beliefs until this remarks, its be these kinds of words that put...
aaron hambridge your video is of a great angle and one can clearly see only one cylinder misfiring In the others video reffered in this...
To all of you who demand Will to take his expression of the site let me remind you WE ARE IN AMERICA and freedom of speech prevails. If you...
Couple of facts here: 1. I understand that Will post is not in any way putting down TIMO quite the contrary WILL is stating his concern in a...
The most common numbers used for fuel pressure are right at the pump. We take it right at the fuel shutoff with a fitting that has a 1/8 npt...
One thing to consider its the engine compression, It has been stated in the forum in past treads , i would double check as you have stated 60pds...
Hi guys , are we talking running 1/8 mile right? Not 1/4 with a 2 speed.
