Recent Content by John Robinson

  1. John Robinson
    Post

    Bill Reichert A/Fuel Dragster Rolling Chassis

    Do you have any 9.5 , 2.91 gear sets for sale ?
    Post by: John Robinson, Jan 30, 2017 in forum: Noonan Classifieds
  2. John Robinson
    Post

    Any advice on setting up b&j clutch packs ?

    Thanks , that helps
    Post by: John Robinson, Sep 30, 2016 in forum: PSI Superchargers Tech Questions
  3. John Robinson
    Thread

    Any advice on setting up b&j clutch packs ?

    Where do you guys run your clutch packs & how do you set them up...ive read the website directions but is there another way?
    Thread by: John Robinson, Sep 25, 2016, 3 replies, in forum: PSI Superchargers Tech Questions
  4. John Robinson
    Post

    Why do FC's vent oil tanks to frame rail?

    We ran into this on the altered, we just ran separate tank to the rear & piped two dedicated hoses underneath .
    Post by: John Robinson, May 30, 2016 in forum: PSI Superchargers Tech Questions
  5. John Robinson
    Post

    Wtb B & J Trans blanket .. 3 speed big boy

    Thank you , I will call them in the morning.
    Post by: John Robinson, May 22, 2016 in forum: Noonan Classifieds
  6. John Robinson
    Thread

    Wtb B & J Trans blanket .. 3 speed big boy

    not too picky as long as it will Cert .
    Thread by: John Robinson, May 18, 2016, 2 replies, in forum: Noonan Classifieds
  7. John Robinson
    Post

    beware of this scammer

    I drove all the way from Texas to Calgary to buy a fc chassis from this fellow .. the chassis wasn't as advertised , it was a ragged out piece of...
    Post by: John Robinson, May 14, 2016 in forum: Noonan Classifieds
  8. John Robinson
    Post

    Lenco burnout procedures

    Yes sir we do that , I measure from the top of the ring & deduct .060
    Post by: John Robinson, Mar 31, 2016 in forum: PSI Superchargers Tech Questions
  9. John Robinson
    Post

    Lenco burnout procedures

    That's exactly what we did & that was the problem ... The guage would go half way up & had a quick pause on the way to 200 .. The lines we had...
    Post by: John Robinson, Mar 31, 2016 in forum: PSI Superchargers Tech Questions
  10. John Robinson
    Post

    Lenco burnout procedures

    Clipper buttons , I'm sure I've been hurting the packs some by shifting mid stride ... We did a burnout the other day on a fresh pack & didn't get...
    Post by: John Robinson, Mar 27, 2016 in forum: PSI Superchargers Tech Questions
  11. John Robinson
    Post

    Lenco burnout procedures

    30 weight non detergent
    Post by: John Robinson, Mar 27, 2016 in forum: PSI Superchargers Tech Questions
  12. John Robinson
    Post

    Lenco burnout procedures

    Yes , 2 turns with no restrictor in pod .
    Post by: John Robinson, Mar 27, 2016 in forum: PSI Superchargers Tech Questions
  13. John Robinson
    Post

    Lenco burnout procedures

    Packs are at .087 & .090 ..fish scale pull is 45 & 50 . One turn out on pod . Thanks for the help ,
    Post by: John Robinson, Mar 26, 2016 in forum: PSI Superchargers Tech Questions