Recent Content by john 111

  1. john 111
    Post

    sheared hemi oil pump shaft

    My old kb pump did the same think,took it out and spun it with a drill,no problems,spins easy.Put it back on and tested with a drill,tight as...
    Post by: john 111, Oct 5, 2006 in forum: PSI Superchargers Tech Questions
  2. john 111
    Thread

    Getting oil pressure

    Just a question/poll type question here. A well known motor builder here said when turning the motor over in order to get oil pressure on the...
    Thread by: john 111, Sep 24, 2006, 6 replies, in forum: PSI Superchargers Tech Questions
  3. john 111
    Post

    Brake Master

    I use the cnc double piston with a single fluid tank, but if I were to do it again,I would use a duel tank type so if there was a leak or blown...
    Post by: john 111, Sep 12, 2006 in forum: PSI Superchargers Tech Questions
  4. john 111
    Post

    Fuel tuning

    Thanks Guys.............
    Post by: john 111, Aug 21, 2006 in forum: PSI Superchargers Tech Questions
  5. john 111
    Thread

    Fuel tuning

    Testing all year and learning the car, we now are getting downtrack and doing it on a regular bassis. I have changed the main a few times per...
    Thread by: john 111, Aug 20, 2006, 4 replies, in forum: PSI Superchargers Tech Questions
  6. john 111
    Post

    Slip Joint FC's ????

    I looked at gilbertsons car closley and noticed that it was a slip joint Murf car.Uprites and diagonals from the drivers compartment foward were...
    Post by: john 111, Aug 20, 2006 in forum: PSI Superchargers Tech Questions
  7. john 111
    Post

    Body to tire clearance

    Same as jap steel,solid mount. Was testing on wednsday,tire was hitting body much more than before. I am going to try a m-t with a 109 roll out...
    Post by: john 111, Aug 18, 2006 in forum: PSI Superchargers Tech Questions
  8. john 111
    Post

    Body to tire clearance

    tire rub I thought I could get away with 2-3/4. Tire rubs even at burnout. 3-1/2 sounds about rite to me. Good luck......................John
    Post by: john 111, Aug 13, 2006 in forum: PSI Superchargers Tech Questions
  9. john 111
    Post

    Mag info

    Thank you guys for all the info. I an going to try a billit base and 1 piece shaft from wizzards and try again.I will use all advice and sort thru...
    Post by: john 111, Aug 2, 2006 in forum: PSI Superchargers Tech Questions
  10. john 111
    Thread

    Mag info

    Noticed the mag on the 4th pass this weekend,moving around pretty good,checked and found the shaft in the housing bent for reasons unknown.Also...
    Thread by: john 111, Jul 31, 2006, 9 replies, in forum: PSI Superchargers Tech Questions