Recent Content by Insanity3

  1. Insanity3
    Thread

    Trans brake launch options

    I have been using the power grid with a two-step at launch (max spark advance) then using a timing curve to launch the car and minimize tire...
    Thread by: Insanity3, Oct 19, 2014, 0 replies, in forum: PSI Superchargers Tech Questions
  2. Insanity3
    Post

    Rod bearings

    Dave, I am no expert but have a similar problem. I have a 4.0-inch stroke billet crank with BME rods, wedge head dodge, stage 6 KB block....
    Post by: Insanity3, Nov 18, 2012 in forum: PSI Superchargers Tech Questions
  3. Insanity3
    Post

    Crankshaft Oiling

    Thanks, I will check into someone who can grind the crankshaft. Do you have to use a special filler rod when welding crankshafts? Dave
    Post by: Insanity3, Sep 9, 2012 in forum: PSI Superchargers Tech Questions
  4. Insanity3
    Post

    Crankshaft Oiling

    Yes, I think so... I purchased it used along with several other parts. The crank is not cracked so I would like to use it, but not if it is going...
    Post by: Insanity3, Sep 9, 2012 in forum: PSI Superchargers Tech Questions
  5. Insanity3
    Thread

    Crankshaft Oiling

    I am currently running a KB/Indy Wedge motor with a billet crank 4.0 stroke and Big block chevy mains. The oiling hole for each rod is extremely...
    Thread by: Insanity3, Sep 9, 2012, 5 replies, in forum: PSI Superchargers Tech Questions
  6. Insanity3
    Post

    rearend preload

    rear end pre-load Kurt, thanks for your feedback. I have seen the spindles on other cars but I have not looked at the details of the...
    Post by: Insanity3, Feb 5, 2012 in forum: PSI Superchargers Tech Questions
  7. Insanity3
    Post

    rearend preload

    rear end preload Will do. Thanks for your help. Dave
    Post by: Insanity3, Feb 4, 2012 in forum: PSI Superchargers Tech Questions