Separate names with a comma.
I have a set of Welds on my car that are 20 years old. The wheels are in good shape but the center sections are too thick to fit the wheel studs...
My trans regularly sees 220+ temps. I've run the trans for 5 years without a problem until that one run I was on the brake a little longer. I...
I have a 1 quart puke tank,with a vent, that will drain back into the trans once it cools. That vent is going to be replaced with a line that...
I use a switch only for a LencoDrive, I believe it's made by Dedenbear. As long as it's rated for 25 amps you're good.
I'll go through RacingJunk and find the websites for all the vendors on there then look at their individual websites for inventory. Also, try...
How common are catastrophic converter failures? Is a 6.1 housing stout enough to contain all the shrapnel or would an additional layer of...
How much end play do you allow for a cam in a hemi? My timing was jumping way more than a single degree before I put the crank trigger on.
Used the 50 Plus for awhile now. We've broken a lot of stuff but none of it because of oil issues.
I have been using the Lucas Sure-Shift on my car since new. 14-71 on a TFX running mid 6s with a LencoDrive. Converter and clutches are perfect....
I use 8 ft LED tubes that are about the size of t5 bulbs. Each one puts out about 4000 lumens, equivalent to a t8 bulb. They all daisy chain...
If I remember correctly, the Lenco buttons aren't recommended for the B&J because it uses 450 psi versus the 250 psi for the Lenco. I purchased...
I have a 10 gauge wire running from the ground post on the coil to the front side of each cylinder head. The torch burned through it both times....
Pulled the motor apart today. Zero damage to the piston, spark plug or bearing. There is a small channel, looks like a burn track, inside the...
I used the MSD kill solenoid (not the air solenoid) and had some weird ignition stuff happen. I pulled that, bought a good toggle switch and use...
