Separate names with a comma.
bob, I'm not a 5 year welder or a welder at all, my questions is if you preclean your tubing 1-2'' weld it -- preclean your tubing 1/2'' weld...
please expain more about the weight transfer, with more or less angle, moving the engine up or down on it center line does it also change the...
you have me thinking again- we run jr. fuel, 396 sb chevy all steel. dyno pulls, 145* engine temp 911 hp, fatten it up - 919 hp 145*temp lean...
sorry chassic ?
very good point on the bearing "tang" as we call it. I will check it to make sure there is enough room. We are running a blown alky motor, it is...
blown375 thanks very much I understand what ya'll are saying about it, our machinist says his hone takes some out of the block and the cap,...
I have more questions than answers and it's too long to ask correctly in writing, so where can I get books on machining and/or theory on machining...
60 -75 dollars just to start it on alc. (alc.oil, filter)