Separate names with a comma.
They did mine earlier this year
Have you tried asking Impact?
Maybe posting a picture of the barrel valve mounted and where it's broken would help
Just to be clear, a pump saver is not a pump loop/sizer, the saver is for when getting off the throttle at high rpm, pump loop/sizer always...
If you're running alcohol, in doing a quick check and assuming no pump sizer, looks like you need around a .215 pill. With your current setup,...
Greg, on mine, I have the pump loop/pump sizer set @ 37 psi with .125 return pill so I can run .075 main pill.
So you've tried 2 different pumps with the same results so chances of 2 bad pumps are pretty high, what kind of line from tank to pump and any...
I know it will sound silly but make sure there is enough fuel in the tank, been there, done that (:
To me, 200 rpm up and down isn't that much specially on marginal tracks and I agree with rb0804 about the zoomies being so laid back. Those front...
I switched over from Valvoline to OnGuard and really like it. I had to use Lucas with the Valvoline to maintain pressure but OnGuard doesn't need...
As a follow up, I tested all the new springs and found one at 8.5 psi, installed it and the idle is great and the response is back, thanks to...
I bought the spring kit from Good Vibrations and it comes with the shims, also, the whole check spring assembly is new.
Yes, blown SBC on alky but with a powerglide. Ever since I ran some bad alky, a series of small stuff have been going bad, the latest is my idle...
Mike; ok, got it and thanks again, and, no general rule of thumb for raising the idle check pressure by, let's say 2 psi, reduce leak down by...
So raising the idle check pressure leans the motor with all things being the same? I would have thought the higher the idle pressure, the more...