Recent Content by Fooler

  1. Fooler
    Post

    Data Logger Recommendation

    RPM Data Logger You can not go wrong with RPM-Performance. Randy is a great guy, easy to work with and the service support is first class.
    Post by: Fooler, Apr 24, 2009 in forum: PSI Superchargers Tech Questions
  2. Fooler
    Post

    MSD 10 Plus

    So then I assume that it would be better to purchase the 8977 unit (boost sensing) over the 8979. This in case I one day would step up and run a...
    Post by: Fooler, Jan 7, 2009 in forum: PSI Superchargers Tech Questions
  3. Fooler
    Thread

    MSD 10 Plus

    I am running an MSD 10 Plus system with crank trigger on my NA injected Hemi. Like to set it up so I can take out timing or put it back in...
    Thread by: Fooler, Jan 7, 2009, 5 replies, in forum: PSI Superchargers Tech Questions
  4. Fooler
    Post

    anyone know HEMI WIEGHT?

    hemi weight I have a hemi block with BAE fuel heads and A-Fuel intake. Hat to pan the weight was 480 lbs (no oil).
    Post by: Fooler, Oct 27, 2008 in forum: PSI Superchargers Tech Questions
  5. Fooler
    Thread

    Starter for KB block

    Just a question for you guys. What starter fits the best for KB block with oil rail on driver side. I have a tilton starter, but it has to be...
    Thread by: Fooler, Aug 27, 2008, 2 replies, in forum: PSI Superchargers Tech Questions
  6. Fooler
    Post

    Hemi intake gasket

    Mr.Gasket # 326 Believe the 326 gasket is for the standard 16 bolt manifold.
    Post by: Fooler, Jul 10, 2008 in forum: PSI Superchargers Tech Questions
  7. Fooler
    Thread

    Hemi intake gasket

    Where can I find some good intake gaskets for BAE fuel heads - 10 bolt. Thanks.
    Thread by: Fooler, Jul 8, 2008, 4 replies, in forum: PSI Superchargers Tech Questions
  8. Fooler
    Post

    Where to measure Exhaust Temp

    Exhaust temps i understand that exhaust temps vary from engine combination to engine combination, but on average with a well tuned engine, what...
    Post by: Fooler, Feb 25, 2008 in forum: PSI Superchargers Tech Questions
  9. Fooler
    Post

    Cylinder Heads

    bolt pattern port location Does an old BAE "fuelhead" and a Stage V head have the same exhaust bolt pattern and port location? Just asking...
    Post by: Fooler, Dec 21, 2007 in forum: PSI Superchargers Tech Questions
  10. Fooler
    Thread

    Alcohol fuel system

    Can standard aluminim AN fittings and steel braded rubber lines be used in a alcohol fuel system, or should some other type of lines and fittings...
    Thread by: Fooler, Dec 5, 2007, 15 replies, in forum: PSI Superchargers Tech Questions