Recent Content by Don R

  1. Don R
    Post

    bellhousing bolt size

    Thanks, we got 3/8" drilled plates from RJ / quartermax and step studs from Wizards.
    Post by: Don R, Feb 15, 2015 in forum: PSI Superchargers Tech Questions
  2. Don R
    Thread

    bellhousing bolt size

    I'm fitting a set of new rear motor plates for a Funnycar. The existing one has 3/8" bolt holes, the new plates are cut for 7/16" How common is...
    Thread by: Don R, Feb 4, 2015, 2 replies, in forum: PSI Superchargers Tech Questions
  3. Don R
    Post

    WTB old Hemi block

    The check has been sent, Thanks for the ad Will.
    Post by: Don R, Nov 15, 2014 in forum: Noonan Classifieds
  4. Don R
    Post

    WTB old Hemi block

    Butch , If you still have that block and you think it's suitable for use with a line up bar and motor plates I'd like to buy it. You can call or...
    Post by: Don R, Nov 5, 2014 in forum: Noonan Classifieds
  5. Don R
    Post

    WTB old Hemi block

    Is that aluminum Butch?
    Post by: Don R, Oct 24, 2014 in forum: Noonan Classifieds
  6. Don R
    Post

    WTB old Hemi block

    Do you have a guess on shipping to 61401? West central illinois.
    Post by: Don R, Oct 21, 2014 in forum: Noonan Classifieds
  7. Don R
    Thread

    WTB old Hemi block

    I'm doing some chassis work and need an old junk hemi block for line up use. Cast would be fine it just needs enough bearing surfaces for the line...
    Thread by: Don R, Oct 13, 2014, 9 replies, in forum: Noonan Classifieds