Separate names with a comma.
Using the exact same setup you have, except a 14-71 @ 50 over, I ran .016 gap with the 7-al box and it worked well. I think you could safely run...
60 psi of compression sounds like the problem. Did a set of shorter rods get in the motor? Is the block, crank, pistons, gaskets, heads, etc. all...
Check the degree ring in relation to TDC. It could be that something changed so that when the piston is at the very top, the wheel is not at the 0...
Well, I didn't say anything was wrong with the intake, as it is obviously working very well. Fuel distribution is very good, and even when the...
Thank you Ash. I will check out what Travis has come up with. I did talk briefly with Dave and Rodney Butler about a turbo motor they were fooling...
OK, so maybe the chamber shape and heat concentration issues shouldn't matter, as long as it is getting the proper a/f ratio. Believe me, it has...
Mike, I am very likely the exception. I am messing with a Pontiac powered funny car, the Dirty Bird. (a real Pontiac motor, not a Big Chief) So, I...
Has anyone tried using down nozzles on a blown alcohol motor? If so, how did it run, and were there experiments with nozzle direction?
