Separate names with a comma.
Since it doesn't pay minimum wage I doubt a B main would fair any better.
https://nhraracer.com/content/general.asp?articleid=72596&zoneid=132
Not fake news or rumor or pit wisdom. Seen it, done it. If you get along fine with it then no problem, carry on.
Bit of an old thread but I wanted to say that wd40 is ok as a decal removal aid but is a real bad idea for fuel systems If allowed to sit it gums...
Since you, in your other thread insinuated the word budget you should be aware that the only thing that makes the current A/F cars "budget" is...
RCD offers some variations. https://rcdengineering.com/product-v2/90-degree-front-magneto-drives
You are only talking about .063 over or .0315 per side.
A couple more candidates. http://www.performancetrends.com/drag_race_centrifugal_slider_clutch.htm...
If you want to call it something other than a pump sizer call it a low speed. Pressure to be set above your idle pressure so it comes on quick....
Did you melt it down?
I don't think gas ports were mentioned by the OP. However if one is inclined to tinker have you seen the Total Seal ring with some "gas port"...
just curious. How do you know it's off?
Porting pistons just sounds wrong. Modifying, shaping and getting rid of sharp edges to improve the flow path is normal in many corners, boosted...
You are likely on a safe tune. 20% will require no changes in your tune. Depending on your setup it might be a bit aggressive at the hit. Some...
