Recent Content by dan1

  1. dan1
    Post

    chevy head selection

    Heads PM Sent about 990 heads i have
    Post by: dan1, Jan 21, 2008 in forum: PSI Superchargers Tech Questions
  2. dan1
    Post

    Cam Bearings

    Bearings That is exactly what we figured out ,after market alum blocks take the all the same bearing, and factory cast iron motors takes 3...
    Post by: dan1, Jan 1, 2008 in forum: PSI Superchargers Tech Questions
  3. dan1
    Post

    Cam Bearings

    Bearings well i tell ya ,my engine builder is beside himself:confused: and so am i:confused:, this aint my first rodeo and it darn sure isnt...
    Post by: dan1, Dec 30, 2007 in forum: PSI Superchargers Tech Questions
  4. dan1
    Thread

    Cam Bearings

    Has anyone here had issues with cam bearing dimesions? went to install mine today and there was as much as .020 difference in .O.D, SO I WENT AND...
    Thread by: dan1, Dec 30, 2007, 11 replies, in forum: PSI Superchargers Tech Questions
  5. dan1
    Post

    Tuning Help

    Tuning Thanks for the help, already picked up the plugs ,went ahead and got both heat ranges so we can experiment on the dyno later. The artical...
    Post by: dan1, Dec 2, 2007 in forum: PSI Superchargers Tech Questions
  6. dan1
    Thread

    Tuning Help

    New Here, So HELLO TO ALL.I have been following posts in tech section awhile,i really need some advise on tuning my motor.what i have is a all...
    Thread by: dan1, Nov 28, 2007, 3 replies, in forum: PSI Superchargers Tech Questions