Separate names with a comma.
4 link is now neutral with no rear steer. Wheelie bars are 3/8 lower on right side (was ~3/4). I didn't move any bars but finally measured the...
More good advice. I was able to straighten the car out with the wheelie bars with the way the car was but it was a nightmare down track. I...
I had a 110 pump on a stock iron headed BBC street motor with hillborn stacks. My first guess at a fuel system was so rich at WOT that it would...
Thanks guys, great feedback. Struts are fixed and revalved. It's a diagonal link, no wishbone. I put 1 flat of preload in it (top right...
Wannabe promod: roots blown BBC, pg 1.80, 4.10, 34.5, 2450 lbs wet. Car was untameable with a bad strut and 3 flats of negative preload. Lots...
Volume shouldn't change boost. If it flows a bunch better maybe you see a small change. Can't say I have direct experience with the change,...
I remember the story now. Pretty sure SSI has a blower dyno. I'm thinking they know exactly how much power it takes to spin theirs vs a PSI and...
SSI had one at PRI 2017 I think it was. Said it was ready to go but they were arguing with sfi about the cert process. Something like sfi wanted...
I have for years been wanting to build a programmable wheelie bar. I'm honestly surprised nobody has done it
.005 or .006 seems pretty close for an average setup. On my 8mm stuff .004 per tooth works well in small windows. For big swings I usually go...
Mike, you are mostly correct. I also got a little on the burnout and more than a little at the hit. I have non-aerated deflectors on the way but...
I've seen and experienced that pointing up vs down doesn't seem to make any difference, seems like the non deflector would result in more charge...
After my first pass witht the engine in front of me, I'm definitely never making another pass with aerated nozzles. Planning on using non...
