Separate names with a comma.
Anti seize under the caps was suggested to me, but it was after metal transfer had already occurred so at that point I don't see it helping. The...
I am at the 2500 hp range with a Brodix aluminum block Hipped and 1/2 filled with steel caps. The cap walk is real bad, I get pissed off every...
Yes, mounted to the servo cover will give you line pressure in low, high and on the Trans brake on a Powerglide
I have had the same oil pressure sensor mounted directly to the engine block for 7 years and has never failed. The only one I have on a hose is...
I have a dragster and made a short extension cable and installed a DB9 D Shell in my dash to connect to. You can also buy the wireless software...
There rods and service is 2nd to none. I would not even consider any other rod
So Will, what is your fuel pressure "happy range" that you like to tune in?
Yea what I should of said in the original post, Hypothetically same BBC engine at 30lbs boost with a pump flowing the same 10GPM at 8K RPM what...
Dave. Yes I understand that, Question was very hypothetical but what I am after is there a performance difference between nozzle atomization at...
I know most seem to like pressure in the 130 psi range but know of some running as high as 190-200 psi. Let's say Same blown BBC, same 30 PSI...
Bingo and nowhere in this thread has the OP stated where the fuel pressure is during the run, only pressure has been boost which is very low for...
I know its not my money buy why dont you trade that 990 pump in for a 110? I have a 540 Chev with 14/71 HH with a 110 gear pump, I had it flowed...
Just comparing your pump and nozzles to my pump and nozzles, 540 bbc with 14/71 HH you are really fat imo
For Alky I use a decent quality single electric burner and stock pot outside, heat it until it starts bubbling hard and then back the temp down...
