Separate names with a comma.
Milodon gear drive I`am currently using my second Milodon gear drive for my blown bbc. The first time i had one is almost 15 years ago. What...
head temp I run the dart pro one water heads without any water on my blown bbc - I monitor the temperature on both heads at the backside of the...
vent filter i use a dry sump pump inlet screen cone (usually epoxied to the oilpan outlets) pushed in the end of the hose that is connected to...
fuel filter i also use the small cone screen that slips into the barrel valve; after the weekend it has trapped some small particles that i...
oil Littlefield recommends 20 oz. for a HH I use syn. engine lubr. Bjoern
Oil in puke tank what is the diameter of the hoses that go to your tank; i think that increasing the diameter of the return hoses slows down the...
lifter spread thanks @ all for the positive input, i`am currently using an installed heigh of 2.05 and with that it`s nearly impossible to...
After about 20 full passes, i find the lifter body in the fork area is widened. Means you can pull the lifter very easily with one finger until...
Kuhl The name Kevin and Kuhl leaves a bad taste in my mouth as i was one of his last "customers" that payed for a blower and never received...
I`am running a 375 cid blown alky big block topped with a 14-71 HH Mert retro here in Germany in comp eliminator. From 5500 rpm up it makes over...
thrust bearing Converter balooning was also my first thought but the pump gear is looking not "unusual" and the thrust bearing surface is nearly...
I`am running a 375 big Chevy blown on alky in comp eliminator. After 6 full passes i pulled the pan to check out the bearing situation. All...
