Separate names with a comma.
Going back to your original post you stated that the engine would consume 8 gallons in 5 to 6 minutes. Simple maths tells me this is not .8...
- missing - popping - piston damage - head gasket I think you might try looking for a lean problem like blocked injector, bad line etc. The rotor...
We used standard vinyl for ours and it lasted for years. Jim
Ah, right first time :o
Gears or chain Hi Graham, what have you been using till this point and is there any large advantage in changing ? We used a good quality...
We had just the same look and problem from worn lifter bores. Went to the next size up lifter and had the block machined to suit and problem...
Connectors I dont know about MSD but we used these on our car. A bit fiddly to fit and you need special crimpers but they lock in good, come...
Steel rods We have run Oliver steel rods in our car with a similar setup to your description for four seasons with no problems. 2000lb dragster...
To fill or not to fill I recommend not filling the Dart big M. It is a good stout block to start with and at 1500 hp you are not working it hard...
Boost guage When we were running a guage before we had a logger, the boost number on the guage would climb between the end of the run and the...
I know what you mean about the missing bolts - strange how they seem to show up later !:) We had problems with converter bolts coming loose. Our...
Hunting Hi GC, Ive sent you a PM Jim
Cracks around pin boss There hasnt been any discussion on this thread about wrist pins . Is it possible a flexing wrist pin is working the piston...
Boost on back of intake Whether Jeffs calc is correct or not I think there is more to this than meets the eye. If all the talk about boost...
Stroke We run a Dart big M 9.8 block and 4.25 stroke. At BDC the piston skirts come approx 1/2 way out the bottom of the cylinder as they are...
