Hi Rob, just wanted to say thanks for dropping those parts off at the Summer Nationals. It's much appreciated. Thanks Phil Crossley
I am interested in 10" clutch stuff ? I talked to Bill D.@ the track Sat. Thanks,Ed Pearsons781-507-5930
Would it be possible for you to contact me, looking for a little advice on a blown small block we are running thanks Les 4065645083
Hi I am in Canada but I want the heads shipped to the US at least. Heads r in burpengary east 13 hours frm Sydney let me know thx
Andre, I sent you an email about the rear ends a week or so ago with no reply, not sure if you got it, I kept up my end of the deal 100% as far as I'm concerned, the new rear end has no brake calipers or wheel nuts and worst of all the bolt pattern is 5 inch not 5.5 . Are you prepared to send me the brake calipers and wheel nuts, I'll order 5 inch pattern centres for my wheels. Matt
Casey: building my 1st blower motor for top dragster...up here in division 3 it's impossible to qualify on nitrous. i'll be running a dart cast bbc with steel main caps, callies magnum plus crank, with je pistons. a couple of questions for you...should i run steel or aluminum rods?? and could you suggest a cam?? thank you very much for the help. greg fedak
Hey if you still have the plans for the jacks you built send them to me if you don't mind. There are many ways around a patent. Trust me been there done that.
