New Complete NRE 528 cid S600 1/2" short hemi w/ tools and spares. Whipple A980

Discussion in 'Noonan Classifieds' started by Soldierboy0098, Apr 1, 2021.

  1. Soldierboy0098

    Soldierboy0098 Active Member

    Feb 17, 2006
    Likes Received:
    Getting out of racing.

    Complete NRE 528 cid S600 1/2" short hemi w/ tools and spares. 4.15*4.5
    All new except crank hub/degree ring, and crank (12 runs magged perfect).

    This was a MSR (Mike Stawicki Racing combo, same as Melanie Salemi's world record combo save heads) It will run 3.60s, Maybe even .50s. Approx 3,800 hp when turned up.

    Noonan Front oiler block.
    Bryant, GRP, MSR/Ross pistons, Total seal, Custom 60mm 4-7 swap MSR cam, 1" CamFX, Manton Tool steel pushrods, S600 heads, Victory, Manton rocker assemblies (Rollers) Williams covers and pan, NRE billet intake, Barnes true dry sump pump, Includes new header gaskets. Just assemble and add oil lines. $35,000 w/ specialty tools and spares Would cost around 60K New.

    Engine Spares: 5 new lifters, Lots of New Tool Steel pushrods, 8 New Valves, 4 New pistons, Pin Buttons, Spark Plugs, blower gel, blower pulleys, degree ring, Torqing spark plug wrench, Main cap puller, Sleeve puller, Sleeve installer, Quick release burst panel assembly (4 bolts), Burst panels, and clamps.
    Complete Modified Whipple A980 (25 runs or so since new)(Ex Rupert/Herbert) Includes, Restraints w/ bag, Pulleys, Belt guard, K valve, ect....Will come fresh from Jim Kyle. $15,000 (I have a new fuel system, and new RCD starter setup for this unit available at extra cost as well.

    Upgraded MSD Pro mag 44 (Not run since gone through by BR) w/ coil, points box, leahy Crank Trigger, New wires, and RCD offset mag drive. $2,500 Includes used spare wires, mag parts, and possibly another crank trigger.

    Call for more details and if your not serious don't waste my time or yours.

Share This Page