EM command module questions

Discussion in 'PSI Superchargers Tech Questions' started by nate4027, Feb 19, 2023.

  1. nate4027

    nate4027 New Member

    Joined:
    May 17, 2017
    Messages:
    25
    Likes Received:
    0
    I have the latest command module activated off a transbrake. My screen is currently red and it says safety box not tripped but when you go into that feature it says teather tripped. I am trying to get it to fire through the crank trigger but have no spark. I have already timed the mag and it runs the way it should. EM said I can just put 12v to the red enable wire and it will bypass the safety box but that did not work when I tried it. Any suggestions are much appreciated.
     
    #1
  2. rb0804

    rb0804 Active Member

    Joined:
    Aug 7, 2010
    Messages:
    671
    Likes Received:
    38
    You have the cables for the burst panel? It runs across the burst panel and ties to the “dog bones”? If that cable isn’t connected, or it’s unliplugged somewhere in the car the screen will be backlit red and car won’t start.
     
    #2
  3. nate4027

    nate4027 New Member

    Joined:
    May 17, 2017
    Messages:
    25
    Likes Received:
    0
    The red ignition enable wire on the timing connector to the module needed to have 12v on it to enable ignition. I was still associating a red screen with no start but that’s not the case.
     
    #3

Share This Page