Separate names with a comma.
Can anyone tell me the oil quantity to go into the lencodrive , this is a three speed and reverser, its the bit with the sump and converter i dont...
i have a three speed lencodrive, there is a bracket underneath with two holes and a bracket on the car that corasponds the two holes, Q do i bolt...
Thanks for your help guys, have a safe and fast 2014
Thanks mike, i have tried it but need a area code to ring from the uk, any help
Can anyone help me, i have purchased a car with a datalogger on board, if i open a flap on top of the computer there is a chip (i presume memory...
Hi guys i need infoon a 16 channel Trace craft data logger, screenshots etc, i need to see how it works out your speed 60` 1320` g Thanks
Check this out, i think we are getting there http://www.youtube.com/watch?v=UczpWt9f-_Q Then on to a good run...
Wayne would you mind sending me some pics, this sounds simple, (hopefully), thanks
Would anyone here have drawings for hemi head stud locations, head blueprints spacings etc, just for a project i am thinking of, any help thanks
Luke, have you thought about making some form of hemi head for the chevy and run a similar stand setup? its something i am thinking about and...
Worth a look, This is 18 yr old Jaynes 1st run with this combo, let me know what you think,...
degreeing how could this be done without any numbers? does in .050 43btdc full lift 100 atdc. ex .050 83 atdc full lift 130 btdc, do these...
I have a cam fitted, sorry i do not know anything about it, it was in engine ( JP1 HEMI )when bought numbers are 659565 and 9111a, before timing...
Does anyone have drawing or measurements for motor mid plate, i have hemi to can at the moment but may need bbc to glide and would like to save...
i am currently running 4.250 crank, in standard height block jp1, i may have the chance of 4.500 crank, will this rotate ok and will i be able to...
the numbers on the end of the cam are 659565 and 9111a journals are gear end 2.00, 1.981, 1.966, 1.950, 1.746 this cam was in the engine when i...
Does this sound right, inlet opening 80 BTDC close 70 ABDC fully open 80 to 97 ATDC ex opening 50 ATDC closing 8 ATDC 0.500 lift on a blown 6-71...
Thats the problem 1.55 to 60ft, 4.30 rear gears 34.5 17-16 M&H rears not old, crower pedal clutch 2 turns = 750 spring chart, 12 grams per finger,...
i am having difficulty getting down the track, funny car with old jp1, blown hemi, crower three disc pedal clutch and 1.41 1.37 three speed cs1...
Cheers guys, checked the bottom end, all fine, i did swap one big end bearings as one a little worn just because i was there, checked over the...