Separate names with a comma.
Evening all Attached are some unusual bearing marks-anyone seen similar? The following is the set up: Aspirated BBC endurance engine .0035 main...
Whos having trouble getting them? I have been told its a billet blank shortage due to: Ukrain issue Companies brought and sold Which company is...
Who has seen a thrust bearing delaminate like this before. .008 clearance. Marks both sides upper and lower. Clevite coated[ATTACH]
Morning Im not having any luck calling or emailing Todd at Racepak does he still work there?. Trying to find out P/N (if it exists) for tire...
Ex aspirated race water block that lost a cylinder. Number 2 web cracked as per pictures both sides of the web. Thinking of converting to a street...
Anyone have a PSI "D" screw lock up? In this case the rear rotors touched the rear plate and chewed out both. it could have been a piece of...
Anyone ever done this? I got some correct Nylatron strip and its too wide to fit in rotor grove. was advised to trim? That is going to be messy....
Anyone know where I can buy some cheers p
Calling all contacts, Im told, but cant confirm that Brooks has closed their doors? Or am I just late on the pickup cause as we are down under....
Evening, I am trying to help out friend with 16-71 Hi helix sitting on a BAE 5 heads 526ci with 4.5 crank. Thinking of turning blower around...
I thought I didnt have a problem, but now I do. Using a single sided sheilded bearing in a triple disk promod. We are chewing up bearings from...
We are running a AJPE older wedge motor with a PSI srew atop. Using a RCD front crank support and iron front 1/2" stud main cap (2 only). I have...
I think I just learnt the hard way the 8973 doesnt like to have any start retard programed in. Engine wouldnt make any spark, remove start retard...
Currently running a AJPE Stage 3 Olds with a RCD crank support and RCD V drive. We run a MSD 44 off one of the V's, Waterman big berther of the...
Anyone heard of the 2 stage throw bearings that the Aussies are using in Alcohol funny cars and pro mods? Who is making these? Is anyone using...
Part 1: I thought I had a "C" rotor PSI screw, now I am told I have a "D" rotor. The size of the lobe ends on the trailing rotor is how you tell?...
AJPE Stage 3 Olds with PSI screw in Pro mod. Using square groove valves with conventional 7deg locks and lash caps with .025+ clearance with no...
Sorry all, Im sure I have seen this somewere here but cant seem to find the thread with search tools (normally spanner and hammer works but not on...
ANyone out there using onboard data gathering computor made by "Race Data Inc". They have a 32 channel system ( I 100) of which there will be a...
Can anyone offer their experience of the life of 14mmHD belts. PSI Screw running currently @92 over but rules allow me to run 108 over down here....