Separate names with a comma.
https://www.thomasfh.com/obituaries/Britt-Allen-Micetich?obId=23146079#/obituaryInfo
We have lost a great racing mind, tuner, mentor, husband, brother, uncle, cousin and friend. RIP...
Pump flowing Flowedge Fuel Systems in Knoxville, Ia. Contact Britt Micetich. 641-871-0158
2 lobe rotor With only 2 lobes I would think there is more volume for air so the displacement per revolution should be more.
Pump mod changes the inlet to feed fuel to both sides of the gear. On the flow bench it will still cavitate, just at a higher rpm that hopefully...
I understand Kármán vortex street effect to be around a blunt object in the stream with flow on both sides. If it happen on a drilled hole then it...
burst plate popping Britt said back in the IHRA days running straight rotors the blower would do this if set too tight on end clearance. It is...
Leak down % of leak has no bearing on lean or rich when comparing others setups. It's just a reference point. Once established it can be used...
Lenco drive cooler plumbing Need to tap into valve body after pressure regulating valve. We feed pressure there and have a return off a tap in...
compression About 11.6 to 1
Iron468, I think most converter companies can make a good converter. Buying from one that is familiar with your setup is best. My preference is...
Slip % To be accurate we had to install input sensor on the lenco drive. Alot of things effect the slip such as tuneup , track, gear ratios,...
May have internal leak, gasket or seal. High pressure leak will aerate and foam the fluid causing it to be overfull and puke out the vent also...
If your converter sprag fails (locks up) you will not notice the difference at stage and launch. It's like a spragless, If it fails and spins...
Powerglide With limited info I would take a shot at the converter. Converter can go bad and create more heat than it can get rid of. If stall...
Fowler F-11 This is what I saw. See page 23 http://www.nitromadness.com/onlinemag/
Has anyone tried a new Fowler F-11 blower yet? Looking for feedback, or would it be better to search the tractor and truck pullers?
I have always used percent of overdrive change and works great. (1.28-1.20)/1.20=.067 or 6.7% Figure the amount of change and then divide by...
Dennis 3rd member We got one from John Scialpi. 626-858-0842 Has been quite a while ago, maybe 10 years.
Servo setting I have always set it per Lenco and never had an issue. Turn clockwise (in) until rotary plate starts to shift then turn...