Separate names with a comma.
What are you all using ? I need something that is around 10ft tall and 8 ft wide. It needs to handle 1000-1200 lbs. I've looked all over the...
I found out they don't make them any more. Prefer new... Just hoping someone has one that don't need it. Thanks
We have a Dart big M deal what is the power handling capabilities of this block ? We have a 11.5:1 PSI D screw 38-40 psi turning 84-8500. I figure...
Looking for a C or D rotor prefer an out of cert, We don't have to cert them. Thanks Craig
http://www.competitionplus.com/drag-racing/news/16323-cast-your-votes-2013-dot-com-awards-ballot. I've voted 6 times...
I'm trying to find some proof like a dyno pull vid to settle a score with a buddy. I'm telling him 3500+ hp & he's calling bs on that. Thank's Craig
What are you guys using & how much use have they seen ? I'm Looking into lithium ion 3/8 drive. Thanks Craig
Has anyone tried this on a blown alcohol deal with 1/16 ring package ?
I talked with Randy and he has the new dash out.... I think they are around $700 with the new board installed in the logger box. The record button...
I was looking at driving this older 1985 ish psi d 220% over turning around 85-8700 rpm I think that's around 20400 rpm screw speed@8500 rpm wil...
I havent pulled it to check yet it acts like fuel is bypassing the spool. engine leans up when shut off but wont die. Has anyone ran into this...
When is it time to step up to the 904 on a bbc ? I've been killing lifters 20-25 psi boost 350# on the seat conv. head manton 7/16 rods T&D shaft...
I'm looking for one that has the coiled wire cord 10 amp ish and need's to be hard to push or have a long stroke. Mushroom type woud be good. This...
I had it but cant find it thanks Craig
I have an oder than dirt D screw that has no sight glass. Was thinkin set the center of the sight at the bottom of the 7 oclock snout bolt hole...
I found one called the #'s in and its was the 4th one made. I know its old. Ive heard something about rotor/screw issues but not sure if it was...
Blower shop blowers I am thinking of buying a bower shop 16-71 retro has anyone had any experience with them ? Are the rotors good like the k-11...
Where can you buy them ? Dont want to have them made big chief heads
Does anyone know someone who custom makes oil heaters? I had a pamphlet from a Co. that followed the IHRA but lost it. thanks Craig
Does anyone know the OD. of the pick up? Is it threaded to smooth?:confused: thanks Craig