Separate names with a comma.
I use marvel mystery oil. Blow it thru everything.
I would think since it is a NA engine, that a .062 copper would safe. Maybe even a .050.
And if I am correct, does this make it a 48 degree lifter angle setup?
Yes sir. From everything I have read, 8 1/2" is std deck so your 8 9/16 is probably same.
From what I have read, 8.5" is a standard deck. 9" is .100 tall. beyond that have not found anything...
I measured as best I could. Got 9.250 across front end of manifold.
Hey guys, looking for info on a KB block. Do any of you know who to contact that can decipher a serial number on a Hemi block? I haven't been...
down loading the run and trying to decipher it. Then if you happen to turn on battery switch, the run is gone. I guess I need to just sit down...
Does anyone else use the Altronics Red Alert EGT system with 8 probes? Is this complicated to use or am I making it hard somehow? The...
Are you talking about the Output Switch?
and??
After further investigation and questions asked, I believe that I can use the MSD 7760 to activate the leanout as desired. Does anyone else use...
Is there a way to wire up the leanout thru the steps in the grid? I have the shifter wired thru the Output Switch. I am wanting to turn the...
Right now I have a FIE single stage leanout on my car that is open only when the transbrake is applied and closes the instant the transbrake is...
No sir. Its a Promag 44/grid setup. On the throttle return springs, don't you want a spring on both sides or just one side?
I have run this combo. I'm on the converter for about 1 sec, on the two step set at 3500. What are your recommendations?
My setup: 572 Fuel Head Hemi LB20 14-71 35% over Timing is set at 32 degrees 1200 Enderle Pump Fresh BAU with 5 9/16 butterflies Blades set at...
I know its old but has there been any progress on this idea made? Would be pretty nice
The MSD site says it will read to 43.5psi. Not sure about it. going to try and give them a call
I have a memory guage that shows highest reading. Wanting to log the boost curve with the Grid. I only run 35-38 lbs boost. Maybe the 7762...