Separate names with a comma.
I have about 50 new pins that are 1.25 and i would like to have them machined down to 1.094 which would still leave me with a .300 wall pin....
I have a set of stage v intakes scribed 1.70 and a set of kluff exhuast with no markings at all. Is there a way to check the ratio's by simply...
Anyone going to be at the DIV 7 race this weekend who wouldn't mind taking my crank to Velasco's or hooking up with Mike Halstead in so ca?...
Recently, I was given an older Autometer 34 channel data aquisation system that was on a fuel car several years ago. Looking for tech sheets and...
Having tough time finding 5/32 o-ring cord unless I want 500 feet of it. Anyone have a good source?
What do you put on the intake port o-rings and manifold to blower o-ring? Or do you leave them dry?
Does anyone have a number or e-mail for the Fanning's (udder nonsense fame) ?
TFX with AJPE stage IV fuel heads. Low compression on alky with 36lbs boost, 44 mag. What plug would do you suggest and at what gap? Thanks
I have a 19 gallon pump and only need about 15 gallons right now (we'll need it all later). I'm plumbing in a checkvalve/hispeed between the shut...
Looked at Will's link didn't see what I need. Going from 2 1/2 inch OD coming off the tank and going to a 1 1/4 OD slip on style fitting on the...
Have you/car you crew on, run a nitro motor (low compression 7-8/1) on straight alky? I understand some of the outlaw altereds run alky, small...
Have AJ STAGE IV heads and trying to figure out what stands to buy and the difference between them. What is the difference between AJ black and...
Looking for a manifold, TFX +100 with stage 5 AJ fuel heads and 1471. I don't want or need the AJ T/F set back deal. Are there manifolds that fit...
I'm putting together a new combo for my altered/funny car (2100lbs wet). We don't have to fit into anyone's rules; just having fun. The goal is...
New to hemi stuff. I've purchased a TFX big bore billet block, bryant 4.14 crank and AJ stage 5 fuel heads. The bore is 4.375 and I'm looking for...
Besides keyways and such which is the best roller lifter for standard BBC + 300? I'm running a good bit of spring pressure but rpm's are 8,000...
What is a reasonable et/mph expectation for my combo, tuning ideas? 566 BBC 4.25 X 4.535 11.25/1 compression Dart 320's by CFE 350 cc's flow...
Just freshened up the blown altered and noticed the sides and top of the tank have been sucked in. While not totally collapsed it is very...
I am getting ready to run a new rotating assembly in my BBC 1471 hi helix 29% over Dart headed 555ci altered with a p/g. Before I was at zero deck...
I have a blown alcohol altered 1500-1600 hp with double wall funny car zoomies. Just picked up a DL 32 data logger. Now I need to decide if I...