Separate names with a comma.
do you run vented nozzle bodys on a screw
run 14 mm with great success on roots, switched to 8 mm gt 33 top used 65 bottom new , broke 3 inch belt on throttle wack. top pulley has a lot...
mick is a top notch guy , its a pleasure doing business with him all the time
what cc would these be
IM INTRESTED IN YOUR CRANK HUBS 1 902 304 9168 BLAIN
looking for +.100 bae screw blower intake
met these guys at gatornationals, great bunch , treated my son and i like family. best of luck
ok i did not know that, thanks mike
thanks ,was not sure about the overdrive difference
thanks mike and will, this screw has strips in the rotors , the rotor has a width around .580 plus. im assuming its a d . i agree with the bench...
running a older littlefield 14/71 front discharge at 40% over on 521 hemi , 42 psi, could we run the screw at lthe same overdrive and have same or...
could in get some pic of blower and history sent to 902 304 9168
its a rcd pump p/p , im putting 4 in pan and 14 in tank on a fresh start. we always check oil and pour back in tank . never measured how much oil...
is it normal to drain pan and put back in tank , there is still oil in tank but it is down a couple of quarts. will it equilize
THANKS , MY COMBO IS THE SAME
currently we run a rcd wobble drive , do we need a offset drive to run mag with screw.
would it be you please send pictures of inside and out to 1902 304 9168 thanks, blain
are pulleys gt or htd
thanks for the info
thanks mike, do you know of a good spot to buy ngk,s