Separate names with a comma.
I know where there is a billet PSI hat to Roots blower adapter that might be available; that with a PSI funny car hat would be about the lowest...
Excellent Robert, thanks for the correction! Jeff J
You may find broken or loose studs /nuts @ the rear of the blower or loose nuts @ the rear of the manifold. If it was a touch lean and detonated...
You would have to measure the crank to cam centerline distance to determine that; it has nothing to do with deck height. You could have any deck...
I have a short deck KB here that the end rails measure 7 5/8" across and a low deck iron 400 block that measures the same and I know that the 400...
The Enderle checks are brass with a steel "needle" and spring although there are others out there. Assuming you have brass Enderle poppets, you...
I would go up to at least 10 psi and as Mike said you can go much higher than that; it would not be too much to go as high as 15 psi or more but...
Yes; pump pressure before the BV. The square BV is a bit limited for flow but your 13 gph pump should be OK. If you want to add a high speed you...
Exactly what Mike said! When talking about "fuel pressure", the standard reference would be the pressure at the pump discharge. Everything down...
If your BV adjustment is very rich it will cause the surge. Leak down the BV to see what it is at so that you can return to the same setting if...
What RB0804 showed you for sale; commonly called pinch valves and they are available in normally open and normally closed. Operated by air or most...
Your answer to the problems you are having is in the sequence you describe; with full timing it leaves and gets up on the tire in .2; then you...
[ATTACH] Some pictures of the offset starter setup I have; the frame, gear and chain. Jeff Johnsen
I have one of those in a pile of stuff in the shop I think; I think it is the offset with handle, a gear and chain, no starter motor. Jeff Johnsen
Yes, I only have about 18-20 random size short jets for those but in looking further through the stuff there are also some of the...
I noticed that Butch Blair has some ads posted in the classifieds and he indicates he has Crower collars/bearings in 4 different lengths available...
Picture Jeff Johnsen
I have some of those; I looked when I had a bit of time over the last week or so and finally found a bin box with some of my remaining fuel system...
Thank you so much for your reply, I would be right on those if they were 4.690 OD as that seems to be what this block uses. The ID would be just...
Thanks Robert, I will do that if I get down to just buying a new set; I was hoping to find some used a bit cheaper although the shipping is a real...
