Slipper clutch

Discussion in 'PSI Superchargers Tech Questions' started by alkydrager, Dec 13, 2015.

  1. alkydrager

    alkydrager Member

    Joined:
    Dec 22, 2010
    Messages:
    127
    Likes Received:
    0
    Are any of you guys running a slipper clutch, in a blown alcohol combination? When i built the car i had aspirations of using a pedal clutch, but I got advice from some pretty good sources to use a slipper. I have pros and cons in my head but just wanted to hear a little from the guys that are running them before i decide.
    Thank you,
    Jody
     
    #1
  2. nitrowannabe

    nitrowannabe Member

    Joined:
    Oct 9, 2006
    Messages:
    414
    Likes Received:
    20
    With the slipper or glide clutch you leave at a high idle and swap feet. Good for nitro cars.To me the pedal clutch is for alcohol. Leave at several thou rpm or a 2 step.
     
    #2
  3. Bob Alberty Jr.

    Joined:
    Jun 7, 2003
    Messages:
    182
    Likes Received:
    5
  4. Bob Meyer

    Bob Meyer Comp Eliminator

    Joined:
    May 13, 2003
    Messages:
    763
    Likes Received:
    36
    If your terminology refers a "slipper" to a "glide" type clutch, then maybe you can get some answers. Anything can slip, pedal or glide.
    Goal is to get boost up with your blown combo with lots of RPM, so unless I'm misinterpreting your question, a "glide" type clutch (not Powerglide trans) does not like RPM to launch, so your good advise is not understandable. I'm old, only slipper I remember is in Snow White!
     
    #4
  5. Comax Racing

    Comax Racing Member

    Joined:
    Sep 20, 2006
    Messages:
    673
    Likes Received:
    7
    When I was looking for clutches this same issue came up. To use a glide clutch or not. And the same answer kept coming, "on an alcohol car you need pump speed (engine rpm) so a glide clutch is not the answer. You will burn discs up. I ended up going to a crower pro sportsman triple disc pedal clutch.
     
    #5
    TADHemiracer likes this.
  6. alkydrager

    alkydrager Member

    Joined:
    Dec 22, 2010
    Messages:
    127
    Likes Received:
    0
    Thank you guys for the input
     
    #6
  7. G Martin

    G Martin Member

    Joined:
    Aug 15, 2005
    Messages:
    67
    Likes Received:
    1
    Sent you a PM
     
    #7

Share This Page