F/C Clutch Pedal Questions

I am in the process of switching the mount of my pedal from the frame, to the can. I know that McKinney makes a kit for this.....does anyone else? I have a Trick can, so at least the tabs need to be Titanium. Also, if anyone has any pics of their complete can/pedal assembly could you please e-mail them to me. I would like to get a few different ideas on the best way to make this work for me. thanks in advance
Darren

 

I think Trick can do this in house ?

 

Mark...yes they can, but i just want to buy the kit. I have seen it done a couple of different ways.....would really like some pics if possible.
Darren

 

Sorry. Not a very good picture. Can is at the chassis shop. Ive seen better pics on the web.

This is Browells work. Only issue was the blow back tab had to relocated for a little extra linkage clearance.
Steve

 

Mine swings from the trans mounting holes on the side, cause thats the way the drivers foot pivots. Ill try to PM you a photo.

 

Can my bellcrank

hey, sent you some pics. just make sure either trick or one of their very few places they authorize does the welding on the can. if somebody they don't like does the welding, they wont recert the can. fyi.

 

I just wanted to say thank you for all the emails and responses from everyone. Thats what it's all about.....helping each other out when we can.
thanks again,
Darren

 

Call Jeff Bohr in Mich. has the drawing & can do the work.
Great work & great guy.

Dan Parker
Parkertech

 

Thanks Dan....I have talked to Jeff before.....super nice guy. I am going to do the work myself though. It just makes it a little easier when you can buy a "kit". I also talked to Trick.....they said it shouldn't be a problem doing it this way. I do quite a bit of Titanium welding at work, hopefully they hold true to their word.
Darren