TFX Oil Pan Question (again)

Guys,

I found a thread on the Nostalgia Funny Car site where someone gave the bolt hole spacing for early and late TFX pans. According to him the early spacing is 11.4" side to side (92 pans) and 10.4" for 96 and later pans. Is this correct? I checked the Moroso pan I have and the 10.4" is dead on. I posted earlier about this and got quite a few responces for which I'm grateful but I was still a bit confused.

I'm still debating with myself as to just what to do with it. I'm strange I guess but the pan is a pretty cool piece of wall art. At the same time I wonder if I should pass it on. Main thing is I would like to be certain that it is what I think it is. A 96 and later TFX pan.

 

Again?

Same question AGAIN? It seems to me that if the valuable information you have received from this site was not clear enough to determine the make and intended fitment for the pan then maybe you should take the information and a photo of the pan and post it all on Racing Junk and let them figure it out for themselves if it fits their application?
Sounds simple enough.

 

OK then,

But look… I’m just trying to verify some info I saw on another site. It’s not like I can just run down to the friendly local NAPA store and compare it to a gasket from their stock to it to confirm what I suspect. The reason I put “again” in the title is because the answers I received were varied which still left me a bit unsure and I prefer to be positive about things.
But I won’t bother you folks any more with this or anything else. To those that tried to help me out, thank you very much. To those that I seem to irritate, I’ll just say good bye.

 

Do you want to sell it? I'm local and can match it up with the drysump pan i have. Im looking for a wet sump pan

 

Have thought about it and if it's something you can use, consider it yours Jeff. Have your # and I'll call you tomorrow.