Separate names with a comma.
I use the heat in my engine to take care of that. Just pull your burndown tubes ASAP after a run or warmup. If you're going to run the valves, get...
Have you used the belt sizing/ratio chart on Good Vibrations?
You change your oil every pass?
Your local welding supplier.
if you dont get it right, the pedal will be very heavy and you wont be able to hold it down very long. your probably looking for .050-.060 clutch...
That's pretty nice... all you need is a grinder, no welding. Just grind a grove on the top for the stem and locks and pop a plastic cap on the...
I would try turning the belt around and run it that way for a while. The problem might just go away? If it moves to the otherside, you should know...
Thats pretty cheap. If its a good part, I would try it. Its probably worth 2k as a conversation piece!
I like gas. We pull the cap to the distribution block and look for 83%, give or take.
With the pump extension cut, I had a 45 on there.
Good one!!!
Have a crew member remind you [with hand signals] to turn things on ,and whatever else.:eek:
The thing will not want to go into gear while the motor is running. On mine,I could do the burnout and find reverse almost all the...
Most of the monster trucks just use the rear tank. I have not seen or heard of a problem with this setup? The tank is higher than the pump.