we need a plate to feed oil into a KB block

We are not able to run an oil pump in the stock location on a KB hemi block. We are going to run a wet sump off of the fuel pump drive with an RCD dual drive and we need to find some sort of way to get the oil back into the motor. I have called KB, BAE and RCD and so far no one makes a plate to do this. I am sure that if we have to we can build one out of aluminum but I thought I might check on here and see if there were any different ideas on this. Thanks Jeff Woolard 913-557-9147

 

Jeff.....
sent you a PM

 

I think that Richard at System 1 mentioned that he could make a block off plate from a damaged pump they had laying around....try him at 559-687-1955

 

I ended up just making one for my KB.