Valve cover question for BNR/Veney heads

Discussion in 'Pit Buzz' started by coyotedale, Feb 9, 2005.

  1. coyotedale

    coyotedale Member

    Joined:
    Dec 3, 2003
    Messages:
    47
    Likes Received:
    0
    We are running BNR heads, and use the valve covers that are fasten down via the threaded plug tube retainers.

    Looking in the rule book, as vague as it is, I am wondering if we must now use studs and nuts.

    Anyone have any insight to this, or are we ok to keep using the origninal covers?
     
    #1
    coyotedale, Feb 9, 2005
  2. rev it up

    rev it up Guest

    not sure of the "rule book"but we do and always have ran studs,, with nuts,,,,seems to be a lot easier for removal and installation,,,,
     
    #2
    rev it up, Feb 9, 2005
  3. Greg

    Greg New Member

    Joined:
    May 12, 2003
    Messages:
    105
    Likes Received:
    0
    We run only the spark plug tubes as valve cover retainers on our Veney heads. There are no provisions for anything else on our valve covers.

    Greg
     
    #3
    Greg, Feb 9, 2005
  4. M Tigges

    M Tigges TAFC

    Joined:
    Jun 11, 2003
    Messages:
    644
    Likes Received:
    1
    What your doing is fine.
     
    #4
    M Tigges, Feb 9, 2005

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM