torques?????

can anyone tell me the correct torque for the flywheel bolts that hold the clutch to the crank
the roots blower to the manifold "blue anodised studs"
bellhousing to the block
kb cast oil pump to block
also what end float should i shim the cam to
and finally of the 2 fittings to and from the oil pump to the system one filter which fitting on the pump goes to the inlet on the filter.....top....or .....bottom this is a wet sump setup



THANKS FOR ALL YOUR HELP THROUGH THE YEAR AND THANKS WILL FOR GETTING THIS ALL WORKING !!!!!!!MERRY XMAS GUYS.......PETER

 

Flywheel to crank--95#/ft.
Blower studs--25# with light oil
Bell hsg. to block: 3/8-16 ---38# light oil
Oil pump long allens---38# light oil
Oil pump 12 point---- 40# light oil
Cam float---- .005 to .015
12 AN aluminum pipe threads--30# with teflon
12AN aluminum fitting nuts 10-14#
Nut behind wheel---450#/ft it's really loose!
Merry Christmas and Happy Racing in the new year!