TAD Parts Sale

1. Spitzer 9" Fab Housing with floater hubs and carbon brakes (Strang/Wilwood) incldng. Wilwood Master Cylinder and Strange 40 Spline Axles, Strange 11" carbon rotors and Strange Carbon Pads - has a slight tweak in it but you would never notice unless you measure with a plumb-bob.
   $3,000.00 - has 14 3/8" mourning distance - same as Strange or Chrisman - have spare rotor and pads for this setup
2. Strange Ultra Case 3.812" Bore and Support, 40 Spline Spool (steel) with dragster coupler and Strange .250" pinion spacer to accept 10" gear - bare/no gear - $1250.00
3. Strange Ultra Case 3.812" Bore and Support, 40 Spline Spool (steel) with dragster coupler and Tom's 10" 4:10 gear w/ 22 runs and .250" Strange Pinion Spacer to accept 10" gear - $1900.00
4. Mark Williams 10" Thirdmember - Alum Thru-Bolt Case (3.812") bore, 40 spline spool (steel). This is the newest unit they produce and has the redesigned angular contact pinion support. I have this with a dragster/solid suspension coupler or a 1480 MW Yoke. This unit has a 10" Toms 4:30 gear with 1 run on it - the entire unit was ran once at St. Louis in 2016 and removed. $2500.00
5. Gorr 16 Port All In One Distribution Block - $350.00
6. Waterman .900 Gear Pump - 21.68 GPM @ 9000 RPM - $1100.00
7. Waterman .900 Gear Pump - 21.73 GPM @ 9000 RPM - all black pump - $1200.00
8. Waterman .750 Gearset/End Plates - flowbench time only - $300.00
9. CP/Carillo Alum. Rods - New: 6@6.900" 2@6.880" - 1.094" pin - std/std - $750.00

Buyer responsible for all shipping charges
Check, Cert. Check, Money Order, wire transfer, PayPal, and Credit Cards (addtl. fee) all accepted

Contact:
Brandon Booher
217.840.1500 - same number for WhatsApp
underby6@gmail.com

 

you still have the Gorr dist block

 

I will take the all in one if available
Dan 410-808-4973