Rods, Pistons, Pins, Pin Buttons, and rings

Rotating assy

A customer purchased my 8x motor less rotating assy so here it is. This combo is a +.100 tall block using a 4.375" stroke and a 4.375" bore, using .220 long rods (7.076") and 1.156" pins it had BAE 5 large valve fat heads and cleared a .900" lift cam. These pistons will make between 12:1 to 12.7:1 compression depending on head and gasket used.

Bryant billet crank, approx 40 runs. Std mains/ std and .010 rods.
New rod bearings
These were installed and rolled over a few times with a breaker bar checking for piston to valve clearance and degreeing in the cam but never ran. 8 new Brooks B2-L rods, 8 new Trend wrist pins, 11 new JE pistons, 8 pairs of new JE pin buttons, and a new set of Akerly & Child's rings. Will work w/ any fathead from a 4 up as long as it has no larger than a 2.425" intake valve, Bigger could be used but would need to be cut, These are pn 387531. There are a couple of boxes of new and used dykes top rings that go with these as well. I may also have 8 spare used pins that would go with if they are the same as whats in there. Asking $2,500+sh. This setup cost about $6,800 new.

3 New in the wrapper Arias pistons which are great if you want to complete the set for cheap or have cheap spares. PN 371241 $100+sh for all 3. That's cheaper than I can get 1 for.

I have 5 new Ross pistons and 3 used Ross pistons same combo as above but with wider valve pockets for the newer larger valve heads

Feel free to call with any questions.
Thanks,
Trevor Sherwood
727-364-4368