Racepac fuel pressure

Discussion in 'PSI Superchargers Tech Questions' started by Iron Mike, Jul 7, 2012.

  1. Iron Mike

    Iron Mike New Member

    Joined:
    Nov 26, 2008
    Messages:
    123
    Likes Received:
    0
    My racepac pro1 has fuel pressure fitting

    can I run fuel to this port or should it be isolated?

    where should this presure be measured , pump or near flow meter after k valve
     
    #1
    Iron Mike, Jul 7, 2012
  2. Mike Canter

    Mike Canter Top Dragster
    Staff Member

    Joined:
    Mar 10, 2004
    Messages:
    4,630
    Likes Received:
    189
    If the Racepak is inside the area where the driver is then it has to be isolated. Where it hooks up to the fuel system depends on what you are going to do with the data. If you using Jetsize tuning software then it should be before the barrel valve. If you are using the data to set a fuel bypass poppet then after the barrel valve. If you are monitoring the fuel pump performance then before the barrel valve.
     
    #2
    Mike Canter, Jul 7, 2012

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM