Quick drive setup or parts

Hi,

Last buyer backed out after telling me it was sold, so it is boxed up and ready to go.

I am going to try a lockup deal so I am selling my never run quick drive and accessories. This unit cannot be converted to a lockup and can be partially but not fully lightened. These units are bulletproof and no mods are needed. Mike Janis, John Salemi, and Mike Knowles all run these units and Janis has went 5.77 with one.

New quick drive unit for high hp application w/ fab pan and 1 3/16" Preferred input shaft (this isn't like the Lenco drive or Bruno, the 1 1/4 has oil flow issues and is not recommended) $5,300 new I will sell mine for $4,300 firm since it is an older unit. Serial number U 5072.

Neal Chance 10" Steel bolt together converter w/ Billet aluminum stator, 50 passes on converter, 1 fin on the turbine was welded (Properly) as it cracked for some reason and as per Marty at Neal Chance this will not affect the unit at all. Everything else looked beautiful and I put a new o-ring on it just because. Serial number is Martorino R35 10983, was what Marty recommended for my high HP (2800+hp) roots dragster. Cost $2,400 new I will sell for $1,500

New JW big block Mopar to Power glide ultra bell (In cert) w/ Quick drive adapter plate, Moly blow back tabs, Flat milled bolt holes for proper torque, the upper center hole was also installed and the bottom threaded hole was opened properly for normal bell housing stud use. JW approved all work to the unit. $460 new I will sell for $250

2 Reactor 139tooth flex plates w/ Converter hub adapter, New ARP crank and converter bolts. One is 2 pass old in great shape and the other is a spare with some nicks and scratches on it but works just fine. These plates won't recert because apparently they go bad if they sit on a shelf for 3 years past the date of the last cert :I Cost over $500 new sell for $200.

This makes the total $6,250 for all of the above.

Calling or emailing is best as I rarely notice PM's

Thanks,
Trevor Sherwood
727-364-4368

 

Bump to the top please

 

Bump to the top please