power grid help

Discussion in 'PSI Superchargers Tech Questions' started by Full Tilt, Jul 11, 2015.

  1. Full Tilt

    Full Tilt Member

    Joined:
    Jan 3, 2014
    Messages:
    70
    Likes Received:
    1
    just purchased power grid 7730, looking for help and advice on how to hook up to a pro mag 44 with a fuel injection enterprise change over/ kill switch. thank you in advance.
     
    #1
    Full Tilt, Jul 11, 2015
  2. Mike Canter

    Mike Canter Top Dragster
    Staff Member

    Joined:
    Mar 10, 2004
    Messages:
    4,630
    Likes Received:
    189
    Its a lot simpler just to shut off power to the Grid to shut down the motor rather than using any special kill switch. Before using the Grid make sure you first go online and make sure you have the latest version of MSDView and not what is on the CD that came with the Grid. After you updated your laptop then hook up to the Grid with a USB cable and connect to your laptop that is connected to the internet and update the Grid software. The Grid can get its power via the USB cable and doesn't have to be installed in the car to do it.

    http://www.msdignition.com/softdwn.htm
     
    #2
    Mike Canter, Jul 11, 2015
  3. Full Tilt

    Full Tilt Member

    Joined:
    Jan 3, 2014
    Messages:
    70
    Likes Received:
    1
    power grid

    thanks aiot mike. I,m new at this electronic world. Would you mind if I called you to help me sort out the fine details.
     
    #3
    Full Tilt, Jul 12, 2015
  4. Mike Canter

    Mike Canter Top Dragster
    Staff Member

    Joined:
    Mar 10, 2004
    Messages:
    4,630
    Likes Received:
    189
    Check your PMs
     
    #4
    Mike Canter, Jul 12, 2015

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM