Offset pully or not

Discussion in 'PSI Superchargers Tech Questions' started by raw, Dec 14, 2009.

  1. raw

    raw New Member

    Joined:
    Jun 26, 2007
    Messages:
    6
    Likes Received:
    0
    Looking at going with a PSI D Rotor on my Brad 5. I have a standard Brad intake. With a standard 3.70in snout on the PSI, will I be using a standard pulley, or the 3/4in offset pullys?
     
    #1
    raw, Dec 14, 2009
  2. REEHL EQUIPMENT

    REEHL EQUIPMENT Authorized Merchant

    Joined:
    Mar 17, 2004
    Messages:
    1,009
    Likes Received:
    1
    Depends on your crank hub.

    They're not all the same.

    The bottom pulley could be closer or further from the gear drive.

    Wait till you have all the parts, then figure it out.
     
    #2
    REEHL EQUIPMENT, Dec 14, 2009

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM