New Browell Lencodrive can, New PST carbon drive shaft, Bruno converter

New PST Carbon drive shaft w/ 1480 U-Joint and Strange short yoke 45 5/8 center to center +/- 1/8" Was for 2 spd Lenco drive in my 63 Vette Pro mod, I run a 3 spd so it will not work for me. Cost $1,700 new will sell for $1,300 + sh

I have a brand new still in the box Browell Steel Lenco drive hemi (May be multi patterned) can, no starter pocket, this was purchased a couple of months ago for a joint project that fell through and is still in cert. Cost over $1,400 new a month or two ago, will sell for $900 + sh.

Also have a Coan steel weld together blower convertor for a Bruno 1 1/4" unit (May work for Lenco drive), came out of a friends pro mod that went 4.30 with a BBC and 4.18 with a hemi. 2800 lb roots car. Serial numbers X5019A 20021311. $250. Older unit but worked good, they went to an aluminum bolt together as part of a sponsorship deal and I bought this one but never went to a Bruno.

Coated Dragster/Altered headers for BAE 4/5 fatheads $250 left over from my dragster. Coating in a couple of spots where some small repairs were made but not worn out and don't look bad.

Thanks,
Trevor Sherwood
727-364-4368
Soldierboy0098@yahoo.com

 

bump it up please

 

Bump it up please

 

Bump it up please

 

Bump it up please

 

Hey Trevor,
Do you still have the Lencodrive can? If so, how much life is left in the cert? Is it same depth as Lenco can? Thanks,

 

Made specifically for Lencodrive so it should be the same. 7.2" is what is called for but I can measure if you want. The cert says it expires 07-2019.

Thanks,
Trevor Sherwood
727-364-4368