New PST Carbon drive shaft w/ 1480 U-Joint and Strange short yoke 45 5/8 center to center +/- 1/8" Was for 2 spd Lenco drive in my 63 Vette Pro mod, I run a 3 spd so it will not work for me. Cost $1,700 new will sell for $1,300 + sh New in the box Browell steel can for Lenco drive/Hemi. Cost $1,400 new sell for $900. Was for a project that fell through. I have a pair of Weld Magnum pro solid (Top fuel) wheel centers that I do not need, 5 on 5.5, These are in great shape cost $1,060 new I'll sell for $400 + sh. 11 or 12 Ross 4.375" Fathead pistons, 1.156 pin bore diam, 1.551 CH. Job #114537. Dome cc 21.52 using a 15.76-15.80 cc gasket and BAE 5 style 96cc chamber makes approx 12.68:1 cr. 1/16-1/16-3/16. Lightly used but in good shape $250 for all of them. ***PENDING SALE*** New ERD 1 1/4" stuffer plate for psi roots blower. Accomplishes inlet mod, very nice contouring, increases efficiency at mid range overdrives (30-50%). $100 New PSI 1.5" stuffer plate for psi roots blower, increases blower efficiency at lower overdrives (25-45%) Paid $200 sell for $75 or $125+sh for both 2 Sets of RCD Crank trigger brackets with bolt on pointers, 1 set black machined to clear a cast cover, 1 set of new polished unmodified $ Price coming soon Large tool tray w/ pneumatic setup leftover from my funny car, it's in the way so $100+sh (It's big and may need to go freight) Was very expensive new. I have some push/pull morse cables will try to get lengths A lot of old KB head studs, 1/2" diam I think, will verify when called. Call with a length if you need them. $200 for all of them. Calling, texting, or emailing is best as I may not catch the messages on ITA.