Gear drive

Discussion in 'PSI Superchargers Tech Questions' started by donnell25-1978, Mar 4, 2010.

  1. donnell25-1978

    donnell25-1978 New Member

    Joined:
    Oct 24, 2008
    Messages:
    35
    Likes Received:
    0
    WHAT WOULD CAUSE A RCD GEAR DRIVE TO GO DOWN ON A TFK 2000 BLOCK??? GEAR DRIVE IS NEW!!!! METAL ALL IN PAN!!! TEETH ARE VERY ROUGH !!! THANKS FOR ANY IFO!!:confused:
     
    #1
    donnell25-1978, Mar 4, 2010
  2. REEHL EQUIPMENT

    REEHL EQUIPMENT Authorized Merchant

    Joined:
    Mar 17, 2004
    Messages:
    1,009
    Likes Received:
    1
    The block may have been line-bored, and the main line is up.

    That's why we sell std, .010, and .020 under crank gears, as well as .010 under idler gears.

    Was the crank to idler lash correct when you assembled it, or was it even checked?
     
    #2
    REEHL EQUIPMENT, Mar 4, 2010
  3. donnell25-1978

    donnell25-1978 New Member

    Joined:
    Oct 24, 2008
    Messages:
    35
    Likes Received:
    0
    Thanks, i didn't assemble motor so i don't know if it was checked??? So have you seen this happen before??? 1-931-224-1473
     
    #3
    donnell25-1978, Mar 4, 2010
  4. john348

    john348 Top Alcohol

    Joined:
    May 29, 2003
    Messages:
    1,348
    Likes Received:
    5
    yep somtimes it chips an tooth or 2
     
    #4
    john348, Mar 4, 2010
  5. Moparious Maximus

    Moparious Maximus Member

    Joined:
    Feb 23, 2009
    Messages:
    401
    Likes Received:
    2
    Yea, I would bet it didnt have enough clearance in the gears.
     
    #5
    Moparious Maximus, Mar 5, 2010
  6. PROMOD63

    PROMOD63 Member

    Joined:
    Jun 6, 2008
    Messages:
    362
    Likes Received:
    0
    Whats the proper clearance ?
     
    #6
    PROMOD63, Mar 11, 2010

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM