Fuel Tank

I Built A New Rear Engine Dragster Alcohol Blower With Sbc.

My Question Is: Can I Located My Fuel Tank Between The Engine And Firewall, ( Near Of Fuel Pump ) Or I Must Have A Firewall Between The Engine And Fuel Tank.............

Thanks, Dan...........

 

Without knowing what your (USA) rule book says, I would recommend you install a piece of ali, minimum of 1/8" 6061-T6 1 x between frame and tank, this one to go from L H side to R H side chassis rails (fire wall) & 1 x between tank & engine, each attached with min 4 x 1/8" tabs (welded to frame) bolted with min 5/16" grade 8 bolts.
If your motor moves forward you will at least have a piece helping stop pulleys etc cutting into your fuel tank.
Always make sure you have the fuel level above your fuel pump prior to starting engine. I have never had a pump failure yet as I have always employed this very system.

 

I would definately put a shield of some sort so a broken blower belt or sneezed blower would not have direct access to the tank.

Also, I would be somewhat surprised if you have enough room for a fuel cell in that location. Do you know how much fuel you will be burning?

EDB

 

Thank You For The Information, The Best Location For My Fuel Tank Is In Front Of My Dragster ( Near Of Front Wheel With A Long Fuel Tube Or ????? ) Firstly, I Want Security, Give Me Your Idea. I'm A Beginner In Dragster Fabrication. The Last 6 Years I Race With A Old C\ed ( I Fit A 355 Sbc Alcohol Blower ......... Et 6.99@195 Mph ) Not Very Safe.

I Wait And I Need Your Help !!!!!

Thanks, Dan..........