Fuel Line

Has anyone ever seen a port nozzle line pinch off during a run? If so any idea what cause it?

Just to answer some questions that may be asked} It was a rubber line without any severe bends in it. It also happened at about 900 feet. It pinched off right before the fitting that screws onto the nozzle.

 

So from the outside you can see that it is "pinched off"? can we see a picture?

Yes, I've had lines go bad on the inside, but there was very little visible evidence on the outside.

 

time to buy some new ones after a long time they get weak and need to be replaced just the weight of the line it will just drop over then trouble starts

 

Thanks Jim. That is what I thought just wanted someone to confirm them.

 

After a while they can develop flappers on the inside leaning the motor.
Thats why I purchased better lines from will hanna.
Good luck

 

I was gonna ask Will to see these lines, compare them to the "Joe Average" line we have been purchasing. Sometimes a couple dollars more can save ya THOUSANDS!